Re: Templates for attributes?

If a node matches more than one template, only the highest priority one is
applied. The second level elements will match both templates, but the
attribute template has higher priority. So you have to make sure that the
first template is applied first and apply the second template next. This can
be done by specifying priorities or modes.

<xsl:template match="/SPC/*">
   <xsl:value-of select="@TITLE"/><BR/>
   <DIV STYLE="margin-left:30px"><xsl:apply-templates select="."
mode="att"/></DIV>
</xsl:template>

<xsl:template match="*[@MONTH]" mode="att">
  Called.
</xsl:template>


Alex

----- Original Message -----
From: "Lee Goddard" <LGoddard@xxxxxxx>
To: <xsl-list@xxxxxxxxxxxxxxxx>
Sent: Tuesday, October 10, 2000 11:12 AM
Subject: Templates for attributes?


> I wish to apply templates to second-level elements,
> to draw out something, and then to further apply
> templates to draw out attributes.  The attributes
> are named the same for all second-level elements,
> so it seems theoretically a good idea to use one
> template for each type.  But when I try this,
> I find that it applies the attribute-only templates
> rather than both.  Any advice would be most
> appreciated.
>
> Thank you in anticipation,
> Lee Goddard
>
> <xsl:template match="/SPC/*">
>    <xsl:value-of select="@TITLE"/><BR/>
>    <DIV STYLE="margin-left:30px"><xsl:apply-templates/></DIV>
> </xsl:template>
>
> <xsl:template match="*[@MONTH]">
>   Called.
> </xsl:template>
>
>
>  XSL-List info and archive:  http://www.mulberrytech.com/xsl/xsl-list


 XSL-List info and archive:  http://www.mulberrytech.com/xsl/xsl-list