[XSL-LIST Mailing List Archive Home] [By Thread] [By Date] [Recent Entries] [Reply To This Message]

Re: Placing an element in a very specific position

Subject: Re: Placing an element in a very specific position
From: Tony Graham <Tony.Graham@xxxxxxxxxxxxxxxxxxxxxx>
Date: Fri, 01 May 2009 14:40:04 +0100
Re:  Placing an element in a very specific position
On Wed, Apr 29 2009 01:39:59 +0100, gkholman@xxxxxxxxxxxxxxxxxxxx wrote:
...
> The column geometry in XSL-FO does not allow you to key out a hole at
> the top of the third column and flow around it.

This sort of scenario is, however, covered by the XSL 2.0 requirements.
See Section 2.1.3, Runarounds, at http://www.w3.org/TR/xslfo20-req/#N65820

Regards,


Tony Graham                         Tony.Graham@xxxxxxxxxxxxxxxxxxxxxx
Director                                  W3C XSL FO SG Invited Expert
Menteith Consulting Ltd
XML, XSL and XSLT consulting, programming and training
Registered Office: 13 Kelly's Bay Beach, Skerries, Co. Dublin, Ireland
Registered in Ireland - No. 428599   http://www.menteithconsulting.com
  --  --  --  --  --  --  --  --  --  --  --  --  --  --  --  --  --
xmlroff XSL Formatter                               http://xmlroff.org
xslide Emacs mode                  http://www.menteith.com/wiki/xslide
Unicode: A Primer                               urn:isbn:0-7645-4625-2

...
> At 2009-04-29 00:42 +0200, Anders.Svensson@xxxxxxxxxx wrote:
>>Hi,
>>
>>I have a problem where I have been asked if I can put an element in the
>>top of the third column in a three-column page. My initial thought is
>>that this can't be done. I have tried to investigate
>>absolute-positioning and floats, but cannot find anything that would
>>seem to do this. I have no idea how it would be possible to decide that
>>it should end up in the top of the third column specifically. In the
>>first column would be easy, and if I could put it in the header that
>>should be easy too, but unfortunately the header is not an option due to
>>the fact that there are space requirements so that each column needs to
>>be utilized completely.
>>
>>Is there any way to do this, or do I need to tell my client that it
>>can't be done?
>>
>>Any suggestions greatly appreciated!
>>
>>Regards,
>>
>>Anders

Current Thread

PURCHASE STYLUS STUDIO ONLINE TODAY!

Purchasing Stylus Studio from our online shop is Easy, Secure and Value Priced!

Buy Stylus Studio Now

Download The World's Best XML IDE!

Accelerate XML development with our award-winning XML IDE - Download a free trial today!

Don't miss another message! Subscribe to this list today.
Email
First Name
Last Name
Company
Subscribe in XML format
RSS 2.0
Atom 0.3
Site Map | Privacy Policy | Terms of Use | Trademarks
Free Stylus Studio XML Training:
W3C Member
Stylus Studio® and DataDirect XQuery ™are products from DataDirect Technologies, is a registered trademark of Progress Software Corporation, in the U.S. and other countries. © 2004-2013 All Rights Reserved.